Thingiverse
Household
Voir le modèle
A normal box
414
Téléchargements
1k
Likes
1
Makes
A normal box with a thread for closure
very resistant and requires approximately a little less than 100g of material. The thread is very good and has a good tolerance ( 0.2mm tolerance\Printer and filament a good calibration is recommended)
Dimensions:
Total height: 85mm
Width: 75mm
Internal height with cap: 61mm
Printing parameters:
Materials at your discretion, PLA works very well in this case i used Esun PLA+
If you like it, offer me a coffee ;) :
paypal.me/marcos971v
very resistant and requires approximately a little less than 100g of material. The thread is very good and has a good tolerance ( 0.2mm tolerance\Printer and filament a good calibration is recommended)
Dimensions:
Total height: 85mm
Width: 75mm
Internal height with cap: 61mm
Printing parameters:
Materials at your discretion, PLA works very well in this case i used Esun PLA+
If you like it, offer me a coffee ;) :
paypal.me/marcos971v
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
