A Windmill

SIZE:
8.5cm. x 15.5cm. x 15cm.(to top of roof)
Assembled sails 18cm. dia.

The model in the pictures was printed on my MakerBot Replicator+ at the default settings of 10% infill and a layer height of 0.2mm. No supports are required if the parts are printed in the orientation shown.

You will need to print
2 x Base A
2 x Base B
2 x Bricks A
2 x Bricks B
2 x Caps
4 x Sails
.
Most parts have slots and pegs for correct positioning. They can be held together permanently with a little superglue. The exploded diagram above shows how the parts fit together.

Begin by assembling the Base parts and Bricks. (Note that Bricks A fits beneath Base A and Bricks B fits beneath Base A.) Insert Base C into the hole in the base of the Main Part and glue a Cap into the top of Base C to prevent it dropping out.

Assemble the Balcony and Rails, and glue into position at the back of the Main Part.

Insert Wheel B through the hole at the bottom of the Tail Bar and glue Wheel A to the end