MakerWorld
3D Printer Parts
Zum Modell
A1 Mini Inline Second Spool Holder
172
Downloads
84
Likes
109
Makes
After moving my spool inline and up with this model, I decided I wanted to make it easier to swap between rolls, but didn't want to lose the inline orientation so it could be placed closer to the wall. After some searching I decided to make one to fit my needs. This fits where the factory spool holder was with the same M3 bolts. I used M3*8. Best of all, it clears the full build volume of the print bed! You could easily pull the filament out of the original PC4 fitting and put the new one in, but if you want to run dual lines into the 4 way port above the extruder, you can thread a PC4 into this rotating model and piggyback onto the original holder with this. I promise its pretty straightforward.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
