A1 Mini LED Light Diffuser

This is a clip-on diffuser for the after-market LED mode that sticks to the bottom of the X-axis gantry.I found the LED light is way too bright and not directing down.Therefore I made this Diffuser.It dims the LED and also directs the light into the heat bed only. 3 print profiles provided: (I recommend white at the base)Single white color for bright light! Half color wall for style!'Pause' pre-set at layer 13, change color Full color wall for the dark power!‘Pause’ pre-set at layer 4, color at layer 4 Installation:Move the extruder all the way to the RIGHT.Align the diffuser to the left end and push up to clip on to the LEDs.Move the extruder all the way to the LEFT.Pull down only the right end of the diffuser to allow passage for the rest LEDs.Slide the diffuser to the right to cover all LEDs and clip back on.Start your next print!!