A8 Bot

I decide to develop this mod because I can't upload any kind of firmware to the mother board of my printer. I tried several times, by several methods, but every time result was negative. So, I have to stay with my native firmware and native kinematics or to change MB to Arduino with Ramps. Also I need thermobox, because I mostly print with ABS plastic and my wife doesn't happy with ABS odour. Then I need the more stable frame because the old acrylic frame was like jelly. Of course, I can print "crutches" like enforcers, corners, and etc...
And I need full bolt-on. Just take from an old printer and put in the same place in new. That's all.

You will need:
2040
mm - pcs
476 - 2

2020
mm - pcs
476 - 3
430 - 4
400 - 4
360 - 2
380 - 6

I take a metal corner from the nearest Hardware store. T-nuts from Aliexpress. I use m4. Total about 220 psc. But I purchase a little more, for any upgrade in future.

I use these tensioners: https://www.thingiverse.com/thing:1428253
X