Thingiverse
Abode Door Sensor Mount
von spacetime_
2
Downloads
0
Likes
0
Makes
I needed to mount the door sensor on an outdoor door where the glue just won't hold. (The rain didn't do it any favors)
This mount has 2 holes that work with standard #8 screws (4.17mm diameter)
The sensors fit snug. To increase water resistance, I have sealed them with duct tape in the back.
This mount has 2 holes that work with standard #8 screws (4.17mm diameter)
The sensors fit snug. To increase water resistance, I have sealed them with duct tape in the back.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!