Thingiverse
ABS calibration cube
von robertkru
17
Downloads
7
Likes
0
Makes
In order to calibrate printing with ABS - when the wall are not easy to break and quality of them are decent you are in the right place with your settings.
Settings I used:
Hotend: 240C (JHead)
Bed: 110C for a first layer, 90C for others,
Bed was painted with ABS glue
You should also notify two very important things:
1. DO NOT use fan for ABS!
2. Build a heat chamber (you can use cardbox even) this will improve the quality of your print and also provide good adhesion for the interlayers.
Settings I used:
Hotend: 240C (JHead)
Bed: 110C for a first layer, 90C for others,
Bed was painted with ABS glue
You should also notify two very important things:
1. DO NOT use fan for ABS!
2. Build a heat chamber (you can use cardbox even) this will improve the quality of your print and also provide good adhesion for the interlayers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
