Thingiverse
ABS temperature gradient test part
von Jim2
1
Downloads
1
Likes
0
Makes
Following a discussion on the reprap forum I made this part to investigate how ABS parts retain heat as they cool.
http://forums.reprap.org/read.php?1,742873
The holes are on 5mm spacing, and penetrate 19mm. The part is 25mm tall and 20mm deep.
http://forums.reprap.org/read.php?1,742873
The holes are on 5mm spacing, and penetrate 19mm. The part is 25mm tall and 20mm deep.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!