Thingiverse
Actobotics Square Bumper
von kwoeltje
5
Downloads
4
Likes
0
Makes
Needed bumper for single Actobotics rail. This was designed to hold a square nut. Inset rim is only partial to make room for standoff (which is used to stiffen channel for motor/wheel mount). I used CA glue to keep nut in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!