Thingiverse
ADHESION TEST - test 3d printer bed adhesion
von muteFPV
4
Downloads
7
Likes
0
Makes
This design starts as a small triangle on the print bed surface and extends at an angle of 45 degrees up to a (vertical) height of ~100mm.
Its overhanging side slowly converts to a half-conical shape, which varies the speed and movements of the print head and print bed during the test.
I printed it in spiral (vase) mode and added weight from the tip of the print after it cooled down to 25 degrees Celsius (77 F).
More info and 3D printing footage in this video: https://www.youtube.com/watch?v=OM1NdekgLlM
Here is how you can easily modify this (and any other) design in Tinkercad: https://www.youtube.com/watch?v=JZXR5rOJ_QM
@ Share and leave a tip if you liked this design! https://www.mutefpv.com/paypal @
Its overhanging side slowly converts to a half-conical shape, which varies the speed and movements of the print head and print bed during the test.
I printed it in spiral (vase) mode and added weight from the tip of the print after it cooled down to 25 degrees Celsius (77 F).
More info and 3D printing footage in this video: https://www.youtube.com/watch?v=OM1NdekgLlM
Here is how you can easily modify this (and any other) design in Tinkercad: https://www.youtube.com/watch?v=JZXR5rOJ_QM
@ Share and leave a tip if you liked this design! https://www.mutefpv.com/paypal @
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
