Thingiverse
adios3D printer
door Bezginbekir
1
Downloads
2
Likes
0
Makes
It is a rework of Huseyin teacher's printer on youtube, https://www.youtube.com/watch?v=NjgCcGldrV4&list=PLpDJwySUb_0TinaK0is5QuNWTSbTMSb68
Frame is built from AL profiles 30x30mm (slot width 8mm). Profile lengths:
Top : 355mm (1x)
Y: 310mm (2x)
Z: 360mm (2x) for about 200mm working height.
For linear bearings you can use 12 pcs LM8UU or 6 pcs LM8LUU. I used makerBot endstops, you can use shortest cable ties to fix them to 8mm rods, do not forget to use them with endstop isolator stl not to make short circuit.
You need 16 pcs 625zz bearings totally, for 4 belt idlers use 2 of them for each idler, use 4 pcs for filament spool holder, 4 pcs is for z m5 lead screws.. So you need to adjust steps/mm to 4.000 for z axis on lcd menu, if your microstep is 1/16.
You need 5 pcs GT2 16 teeth gears. 3 of them used on top side to move z axis with only one motor. Closed GT2 belt lenght is 784mm.
Lcd and ramps holder parts are from my old lovely reprap printer Funbot, https://www.thingiver
Frame is built from AL profiles 30x30mm (slot width 8mm). Profile lengths:
Top : 355mm (1x)
Y: 310mm (2x)
Z: 360mm (2x) for about 200mm working height.
For linear bearings you can use 12 pcs LM8UU or 6 pcs LM8LUU. I used makerBot endstops, you can use shortest cable ties to fix them to 8mm rods, do not forget to use them with endstop isolator stl not to make short circuit.
You need 16 pcs 625zz bearings totally, for 4 belt idlers use 2 of them for each idler, use 4 pcs for filament spool holder, 4 pcs is for z m5 lead screws.. So you need to adjust steps/mm to 4.000 for z axis on lcd menu, if your microstep is 1/16.
You need 5 pcs GT2 16 teeth gears. 3 of them used on top side to move z axis with only one motor. Closed GT2 belt lenght is 784mm.
Lcd and ramps holder parts are from my old lovely reprap printer Funbot, https://www.thingiver
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
