Thingiverse
Adjustable angle mount for Rigidbot LCD panel
von racatack
65
Downloads
39
Likes
2
Makes
No more bending over to read the display - angle it up!
Print four pieces of the basic part/bracket. Press a 6-32 nut into the hex socket on two of them and mount those to the LCD panel with M3-8mm screws. The nuts should face inward (toward each other.) Mount the other two brackets on the Rigidbot plastic front panel with the empty nut cavities facing out.
Use a 6-32 screw from each side to join the LCD brackets to the front panel brackets.
The screw holes are deliberately undersized and need to be cleaned up with about a 9/64" drill.
Printing with the nut cavity facing the build plate worked best for me.
Print four pieces of the basic part/bracket. Press a 6-32 nut into the hex socket on two of them and mount those to the LCD panel with M3-8mm screws. The nuts should face inward (toward each other.) Mount the other two brackets on the Rigidbot plastic front panel with the empty nut cavities facing out.
Use a 6-32 screw from each side to join the LCD brackets to the front panel brackets.
The screw holes are deliberately undersized and need to be cleaned up with about a 9/64" drill.
Printing with the nut cavity facing the build plate worked best for me.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
