Thingiverse
adjustable cannon
von betalab
1
Downloads
2
Likes
0
Makes
Adjustable Cannon
This model is a simple test, to check some tolerances, in particular the 2mm holes, used in this case for the moving parts in which I inserted the 1.75mm filament.
Software: Autodesk 123D Design, Cura
This model is a simple test, to check some tolerances, in particular the 2mm holes, used in this case for the moving parts in which I inserted the 1.75mm filament.
Software: Autodesk 123D Design, Cura
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!