Thingiverse
ADJUSTABLE CELLPHONE MOUNT
von millenium
14
Downloads
12
Likes
0
Makes
Just for fun!!!
0.20-0.25 mm layer thickness
20-30% infill
extra things need it: two screws 1/2 large X 3/8 thread with 1/2 hexagonal head and 1 nut with the same thread and head of screws. use one of the screws to make or draw the thread on the sprocket.
mount part 02 it was improvised this part will be changed for 360 degrees articulate arm part this last piece is in progress.
enjoy it!!!
0.20-0.25 mm layer thickness
20-30% infill
extra things need it: two screws 1/2 large X 3/8 thread with 1/2 hexagonal head and 1 nut with the same thread and head of screws. use one of the screws to make or draw the thread on the sprocket.
mount part 02 it was improvised this part will be changed for 360 degrees articulate arm part this last piece is in progress.
enjoy it!!!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!