Adjustable IKEA motion sensor mount

This mount is adjustable up/down and left/right.



There are two backplates to choose from:

-One for two 10x2mm magnets

-One with a flat surface for either taping/gluing in place. Or perhaps print it with 100% infill and drill a hole for whatever size screw you want to use.


Hardware required:

2x 14mm M3 bolts.

2x M3 nuts.

(Optional: 2x 10x2mm magnets)



Parts needed for print:

1x Backplate (Choose what version you want)

1x Joint

1x Connector (this one goes into the motion sensor)

2x Wedges (these lock the connector into the back of the motion sensor)



I would also recommend printing with supports for the magnetic backplate just so the magnets doesn't stick out from the holes.