Thingiverse
Adjustable Phone & Tablet Stand
por Mike-vom-Mars
385
Descargas
318
Likes
9
Makes
ADJUSTABLE PHONE & TABLET STAND
- Tiltable
- Print-in-place
- No screws needed
- No assembly needed
- For phones and tablets
While most phone / tablet stand provide a single, static position only, this adjustable phone and tablet stand lets you choose your preferred tilt angle. It prints ready-to-use, so no assembly, screws or other parts are needed. The included phone stand is designed to hold phones up to 6", while the included tablet stand is designed for phones or tablets up to 8".
PRINTING:
- Layer height: 0.1 - 0.3mm
- Use a raft for best heatbed adhesion
- Infill is not required (but can be used for better stability)
- Print the parts in the provided position to ensure that the joints will work properly (enable supports).
UPDATE:
I also uploaded an alternative version: https://www.thingiverse.com/thing:2785088
- Tiltable
- Print-in-place
- No screws needed
- No assembly needed
- For phones and tablets
While most phone / tablet stand provide a single, static position only, this adjustable phone and tablet stand lets you choose your preferred tilt angle. It prints ready-to-use, so no assembly, screws or other parts are needed. The included phone stand is designed to hold phones up to 6", while the included tablet stand is designed for phones or tablets up to 8".
PRINTING:
- Layer height: 0.1 - 0.3mm
- Use a raft for best heatbed adhesion
- Infill is not required (but can be used for better stability)
- Print the parts in the provided position to ensure that the joints will work properly (enable supports).
UPDATE:
I also uploaded an alternative version: https://www.thingiverse.com/thing:2785088
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
