Thingiverse

Adjustable saw push

von thecadman99

1.2k Downloads

623 Likes

3 Makes

Zum Modell

If you want the very best- buy the commercial version. Support the US economy- we need all the help we can get! With that said, you can give an adjustable pusher a try with this print THEN buy the commercial version.

Designed to work with 1/4" carriage bolts, washers and nuts.
You will need:
Carriage bolts- 1/4"
Five- 1" bolts
Two- 1-1/4" inch bolts
Two- 4" bolts
Nine 1/4" nuts
Nine 1/4" washers

Designed for minimal support:
You should only need support when printing parts where the carriage bolts are countersunk into the body, and you may not need that if your bridging working well.

The adjustable centerpiece has a slide down hook for pushing difficult-to-grip piece.

I used shelf liner and super-glued it to the bottom surface- If you find a better material, please comment and share.

If there is enough interest, I will add a thinner fence-side plate.
This design is for testing purposes only- BE SAFE.

adjustable grip adjustable table saw grip gripper push stick pushstick safety push Saw push Tablesaw table saw adjustable grip adjustable table saw grip gripper push stick pushstick safety push Saw push Tablesaw table saw adjustable grip adjustable table saw grip gripper push stick pushstick safety push Saw push Tablesaw table saw

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat