Thingiverse
adjustable spanner
von dan241297
43
Downloads
37
Likes
0
Makes
The handle and slider are printed in two mirrored halves and then glued together as this was the easiest way to do it. Parts may need filing to get it to work smoothly.
A 40mm M3 screw holds the worm gear in place and cuts its own thread into the handle so no nut is needed.
A 40mm M3 screw holds the worm gear in place and cuts its own thread into the handle so no nut is needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
