Thingiverse
AFM Tip Adjusted
von West3DP
2
Downloads
2
Likes
0
Makes
Update 10/28: I also had trouble getting the tip to slide smoothly over the surface, so I rounded out the end. Less accurate but more clear during demonstration. This is Tipv3
I printed the AFM model at 175% it's normal size
Cura for Ultimaker and Lulzbot both had trouble processing the original tip file, either placing a gap between tip and shaft or only importing part.
So I just heightened the shaft slightly to insure overlap and re-exported as an STL. Sliced fine and printed great
I printed the AFM model at 175% it's normal size
Cura for Ultimaker and Lulzbot both had trouble processing the original tip file, either placing a gap between tip and shaft or only importing part.
So I just heightened the shaft slightly to insure overlap and re-exported as an STL. Sliced fine and printed great
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!