Thingiverse
Aggretsuko - SING!
von doesntfearzeus
174
Downloads
151
Likes
8
Makes
Went looking for a model of Aggretsuko to print but all I could find was Retsuko. It was a great model, but not with the attitude she needed. I decided to turn her into her true form. This has been a process of picking it up and putting it down for months but I finally finished it and I'm really happy with the results.
It was alot of work using MeshMixer to change the poses, repose the fingers and rebuild the face. This was only possible because the original model was separable and I could work on parts individually. Uses 3D Builder to take from images and extrude all of the details on the face. The mouth came out better than I expected.
Didn't understand the teardrop base on the original, so I decided to use a Ying Yang symbol as the base to symbolize the two forms of Retsuko.
I do suggest printing close to the STL size of 120mm since the fingers are pretty small and will be very fragile at smaller sizes. The print photos are from a slightly earlier of the model. Made some cl
It was alot of work using MeshMixer to change the poses, repose the fingers and rebuild the face. This was only possible because the original model was separable and I could work on parts individually. Uses 3D Builder to take from images and extrude all of the details on the face. The mouth came out better than I expected.
Didn't understand the teardrop base on the original, so I decided to use a Ying Yang symbol as the base to symbolize the two forms of Retsuko.
I do suggest printing close to the STL size of 120mm since the fingers are pretty small and will be very fragile at smaller sizes. The print photos are from a slightly earlier of the model. Made some cl
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
