Thingiverse
Air Filter
6
Downloads
5
Likes
0
Makes
Filter housing for incoming or outgoing air.
Designed for pipes with a 105mm diameter.
The carbon filter I had was for a Nissan Qashqai 2006 1.5 diesel. You might be able to find them cheap at a car parts outlet. This filter is 20mm deep.
You'll need to cut the filter medium so it's 105mm square.
I used bathroom silicone between the filter edges and the housing to prevent leakage.
Superglue the two parts together and attach to the vent with tape.
20% PLA
Designed for pipes with a 105mm diameter.
The carbon filter I had was for a Nissan Qashqai 2006 1.5 diesel. You might be able to find them cheap at a car parts outlet. This filter is 20mm deep.
You'll need to cut the filter medium so it's 105mm square.
I used bathroom silicone between the filter edges and the housing to prevent leakage.
Superglue the two parts together and attach to the vent with tape.
20% PLA
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
