Thingiverse
Airflow PC Case Mod
por brk017
20
Descargas
31
Likes
0
Makes
Wanted to give my PC case better airflow but couldn't find any designs I liked so I made something simple. This is the first model I've made so far and I'm pleased with the result. Lowered my Idle CPU temps by 5-10 degrees Celcius with an AIO.
Cut with a Demel and sanded the edges until it was a snug fit then epoxied the inside for extra stability and to make sure it wouldn't rattle.
To get a snug fit, trace the outside of the print then mark 3mm to the inside. I cut just inside of those lines then sanded the edges until it snapped in.
Hopefully will work for a variety of cases.
Cut with a Demel and sanded the edges until it was a snug fit then epoxied the inside for extra stability and to make sure it wouldn't rattle.
To get a snug fit, trace the outside of the print then mark 3mm to the inside. I cut just inside of those lines then sanded the edges until it snapped in.
Hopefully will work for a variety of cases.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
