AirGradient DIY Basic Enclosure

This DIY enclosure for AirGradient Basic DIY indoor air quality monitor was inspired by my Ecobee thermostat. It features a baffle to separate the PM sensor fan intake and exhaust and it features a separate enclosure to isolate the temperature sensor from the heat generating electronics. There are two different face plate designs, plain and ‘fancy’. There is also a mounting adapter that can be used with 3M command strips to hang the enclosure without screws. Use 4 each M2 x 4mm heat set inserts for the board and an M3 x 4mm long heat set insert for the sensor locations.

I generally followed the instructions and self-sourced the components as described in the AirGradient Basic DIY instructions located here: https://www.airgradient.com/documentation/diy/

Notes:

Just in case I needed to swap the Wemos D1 Mini in the future, I deviated from the AirGradient DIY instructions by mounting the Wemos to a header soldered to the AirGradient Board. This raises the oled screen up higher th