Ajax uartBridge case

This is a self designed case by carefully measuring Ajax uartBridge with calipers. There is no affiliation or endorsement in any way from Ajax. The case is pretty tight, and requires pretty precise tolerances both for fitting PCB and for connecting parts together.An opening is present on the side of the case for a ribbon of 4 dupont wires for connecting UART and power. The model can be printed in any non-conductive plastic you want, but it is advised to use simple plastics such as PLA, ABS or PETG - actually, the board does not heat up a lot, so PLA is a reasonable choice. It is strongly discouraged to use any plastics with mixins (conductive, CF, GF, etc.), because they can negatively influence the radio signal. Design choice of colors and inside walls was made so that light from the board status LEDs can shine through the white hat while light bleed to other sections is reduced to minimum. You can, of course, print it in full black (if you do not have an AMS or want to block light al