Alien III. HueForge

Picture source - author: Brett Voutier  @brettvoutier Then used HueForge v0.9.1 to create the model.   Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. The model size is 150x150 mm. You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Min Depth of 0.64mm. The Max Depth is 2.2mm and the Actual Depth is 2.2mm   It is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.   These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use. Filaments Used: PLA Anycubic Black Transmission Distance: 0.3 PLA BambuLab Basic Orange Transmission Distance: 4.8 PLA Elegoo Matt White Transmission Distance: 6 This print uses 3 unique filaments   Swap Instructions:  Start with Black  At layer #9 (0.8mm) swap to Orange  At layer #14 (1.2mm) swap to White for the rest.