Thingiverse
Electronics
Zum Modell
alpha.0110
95
Downloads
88
Likes
0
Makes
**EDIT 04/06/19: I've updated the top half file for stabilizer compatibility. The older top half file does not work with a stabilizer unless you file the cutout. Please use the new file!**
**EDIT 03/21/19: I've added an extra bottom half file with screw holes and closed bottom, designed by SlipperyPeteED. The new bottom has been tested and works with self-tapping M2.5x10 screws. In testing, the screws were screwed directly into the top half only until flush with the bottom half. The tolerance using these screws was very tight and going past the surface of the bottom half of the case would cause the screw tips to poke through the top of the case. Tests will be done with M2 screws and shorter lengths.**
The second in a series of vintage-inspired printable cases for Alpha, a 28-key mechanical keyboard PCB by /u/pyrocrastinator.
A high-profile case in the style of the Apple M0110 with 9 degree angle, 2.5mm integrated plate, and cutouts that allow switches to clip in.
The to
**EDIT 03/21/19: I've added an extra bottom half file with screw holes and closed bottom, designed by SlipperyPeteED. The new bottom has been tested and works with self-tapping M2.5x10 screws. In testing, the screws were screwed directly into the top half only until flush with the bottom half. The tolerance using these screws was very tight and going past the surface of the bottom half of the case would cause the screw tips to poke through the top of the case. Tests will be done with M2 screws and shorter lengths.**
The second in a series of vintage-inspired printable cases for Alpha, a 28-key mechanical keyboard PCB by /u/pyrocrastinator.
A high-profile case in the style of the Apple M0110 with 9 degree angle, 2.5mm integrated plate, and cutouts that allow switches to clip in.
The to
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
