Thingiverse
Amplifier
por atartanian
1.2k
Descargas
1.9k
Likes
1
Makes
This telescoping print is designed to amplify an iPhone 6 internal speaker's audio. It prints all in one piece which starts off around a cubic foot large and then spirals out to be about 3' x 3' x 1.5' (1m x 1m x 500cm) large!
This is a monster print. It was designed for printing on a [MakerBot Z18](http://store.makerbot.com/replicator-z18) and uses a large portion of the total print volume (12"x12"x18").
The print takes about 13 days of continuous printing with standard settings and consumes close to 10 lbs of filament!
If you should choose to attempt this behemoth, check out my notes in the print settings section
This is a monster print. It was designed for printing on a [MakerBot Z18](http://store.makerbot.com/replicator-z18) and uses a large portion of the total print volume (12"x12"x18").
The print takes about 13 days of continuous printing with standard settings and consumes close to 10 lbs of filament!
If you should choose to attempt this behemoth, check out my notes in the print settings section
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
