AMS 2Pro Buffer Relocation Bracket

This model involves relocating your AMS buffer to the back of your AMS with a bracket. This reduces filament change times by as much as up to 44%. This time savings will vary depend on print time and number of color changes etc. It also creates less strain on the motors, but most importantly saves you time. My default profile for the P1S my filament time changes are about 30 seconds. With my new custom profile my filament time changes for load is around 4-5 seconds, and unload 6-8 seconds. This might not seem like much until you are doing many color change prints. Here is an example I did, I made a print that was 55:22 and 19 color changes, after this mod the same print was 44:57, that's a 11:25 min an 25 sec faster, or 18.81% overall reduced print time. I added a picture looking from the top of the AMS, the pictures from the back are a little deceiving. Some have said that it has 90 degree bend coming out of the AMS. The bend is not 90 degrees, it is a upwards and outwards to the