MakerWorld
3D Printer Accessories
Zum Modell
AMS PTFE IN
1
Downloads
1
Likes
1
Makes
I created this guide for the ptfe because I have the AMS on the side of the printer and it remains lower, consequently the ptfe tube made a couple of bends that I didn't like. This model uses up to 4 6mm x 3mm magnets, I am currently only using 2 and it does not move, in case it vibrates there is the possibility of installing up to 4 magnets. The hole for the magnets is VERY PRECISE, to install them I used a piece of plastic and with a little pressure they entered the seat and no longer move! Made of PETG without supports. Link to magnets: https://www.amazon.it/dp/B08F7HNG45?ref=ppx_yo2ov_dt_b_product_details&th=1
spluca80 veröffentlicht auch auf
17 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
