Anachrony Insert

The goal here was to make an insert that fits on the Ender3 or smaller, and would fit the original KS and the Fractures of Time expansion (which isn't out yet). So no guarantee it will fit the expansion until its out. but it should hold most of it and hopefully either small reprints or some extras in a bag.

I had to make a couple of compromises.
- the miniature storage isn't great when the box is on its side, if your minis are painted that would be an issue but otherwise its minor.
- does NOT fit sleeved cards, I needed every mm there just wasn't room
- The player board where you place you leader is not included in the player boxes, so they go on top of the insert with the other card board. I need to put the player boxes on their sides and that board is taller than the box.

You will need to print 1 of each file except the player Box, you need to print 5 of those, there is a separate lid file for each faction.

The ExoSuitBig files will fit 5 sets of exosuits. Thes