Thingiverse
Anchor
von YBMatt
72
Downloads
61
Likes
1
Makes
A simple anchor. Designed to take up as much height and width in space on a 200mm x 200mm printbed. Printed on a Prusa Mendel i2.
Update: 6/20/2014
New anchor based on my brother's drawing. That would be the one with the three arrows on each side of the anchor.
Update: 6/20/2014
New anchor based on my brother's drawing. That would be the one with the three arrows on each side of the anchor.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
