Thingiverse
Android Assistant
von djtremors
13
Downloads
8
Likes
0
Makes
I've got a Raspberry Pi Zero W and a Pi 3 which I'm building this android case to install it as a google assistant. Still working ideas on ports, power, mic and speaker placement etc.
The shell is have future adaptors to slide in the Pi 3 or Zero or any device you want making it flexible to any SBC.
The neck piece slides down into the body and the head slides into the neck. The reason the neck is super thin is so that bright LEDS can sit behind it and light up through white filament.
The head so far is the only piece that needs support, trying to find a way (without printing upside down) to do it without support.
Updates:
head (V1) would require support, head-V2 was redesigned differently and has 45angles inside to help prevent the requirement of support but may struggle at the top ears sticking down. will touch up.
Most of V2 files are enhancements, peg parts are chamfered to make inserting easier and also made the pegs slightly narrower as my prints were too hard to i
The shell is have future adaptors to slide in the Pi 3 or Zero or any device you want making it flexible to any SBC.
The neck piece slides down into the body and the head slides into the neck. The reason the neck is super thin is so that bright LEDS can sit behind it and light up through white filament.
The head so far is the only piece that needs support, trying to find a way (without printing upside down) to do it without support.
Updates:
head (V1) would require support, head-V2 was redesigned differently and has 45angles inside to help prevent the requirement of support but may struggle at the top ears sticking down. will touch up.
Most of V2 files are enhancements, peg parts are chamfered to make inserting easier and also made the pegs slightly narrower as my prints were too hard to i
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
