Thingiverse
Android Robot Skiing
von Balex3
19
Downloads
23
Likes
0
Makes
Added holes at the bottom of the body to connect skis.
Ski poles fit into hands with 4.5 mm hole.
Support might be needed only for ski and ski poles but not critical.
Body printed with 0.2 mm layer and the rest with 0.15 mm layer.
Infill 15-20% (I used Cubic infill in Cura)
The rest of parts and assemble instructions see in Remix Source.
I haven't painted my print yet but used 3D Builder to emulate painting.
Would be happy to see your makes.
Any comments/suggestions are welcome.
Ski poles fit into hands with 4.5 mm hole.
Support might be needed only for ski and ski poles but not critical.
Body printed with 0.2 mm layer and the rest with 0.15 mm layer.
Infill 15-20% (I used Cubic infill in Cura)
The rest of parts and assemble instructions see in Remix Source.
I haven't painted my print yet but used 3D Builder to emulate painting.
Would be happy to see your makes.
Any comments/suggestions are welcome.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
