Thingiverse
Engineering
Model downloaden
anemometer
20
Downloads
16
Likes
0
Makes
Holds a turbine. The main axle will be 5mm carbon fibre rod. The vertical shaft is a piece of an old fishing rod. Hollow, so a rpm counter can go through it up to the horizontal shaft.
The block in the support piece will hold a circuit board, which holds four stacked rotary encoders.
The bearing holder at the bottom is separate, so everything can be fit inside.
Also tells direction, using 4 bit shaft encoder.
The block in the support piece will hold a circuit board, which holds four stacked rotary encoders.
The bearing holder at the bottom is separate, so everything can be fit inside.
Also tells direction, using 4 bit shaft encoder.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
