Thingiverse

Anet8 toggle switch mount

von Luucky13

4 Downloads

4 Likes

0 Makes

I designed this so i can add a toggle switch to my Anet8. printed in the position shown no support needed, i printed it in PLA but ABS worked good too,
Use the miniature toggle switch on EBay . I added a hole on either side for zip ties to use as strain relief for the wires

Anet 8 Anet8 switch Anet A8 fan Fan switch mount Mount for switch on off switch power switch switch bracket switch mount toggle switch Anet 8 Anet8 switch Anet A8 fan Fan switch mount Mount for switch on off switch power switch switch bracket switch mount toggle switch

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Warum?

Supports nötig

Einteilig Supports nötig

Supports 2/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker