MakerWorld
Measure Tools
Ver Modelo
Angle Finder
2k
Descargas
289
Likes
1.3k
Makes
I needed a simple angle finder, and didn't find one on here, so made this one! Each tick on the face represents 10 degrees I recommend printing it out of PLA Tough/Plus/Pro, PETG, or ABS/ASA, as I'm not sure if basic or matte pla will hold up for the hinge part, when you snap it together. The fit is meant to be a little tight/stiff, so when you set it, it stays.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
