Angled Toolbox Labels

My first model and still a beginner at 3d printing. I welcome your suggestions for improvements. Prints great for me using PLA on Bambu Labs P1S without supports. I wanted two colors and at an angle for readability (especially on lower drawers), but I don't have an AMS. This design allows you to pause the 'label inserts' plate print job (layer 11 for me) and only change filament once.The size and angle are designed to make it easy to read standing in front of a mechanics toolbox.The two magnets of 12x2 hold good for me, but you could also easily use double sided tape.I used 15% infill but you could likely go with less. Also included a label to apply flat on drawers that are too narrow in height for the base or upper drawers that are near eye level.It is thicker to accommodate magnets and will not fit in the base. I couldn't find a model that met my needs, so I hope this helps someone else.