Thingiverse
AnkerWireless Stand with socket
von cmwoodman
0
Downloads
0
Likes
0
Makes
I was inspired by various designs, but i started from scratch to make sure i had the measurements right and added a socket on the back so i could make it work with arm hulabalo made (https://www.thingiverse.com/thing:3837676)
my prototype was in PLA and all the fittings were good. when i printed it in ABS it seemed to expand a little, so i had to use rubberbands in the partial ring for the charging pad.
I also used the spacer to accommodate smaller phones.
the socket is set to use the larger (14mm) arm one piece. You will have to sand it for a smooth fit.
my prototype was in PLA and all the fittings were good. when i printed it in ABS it seemed to expand a little, so i had to use rubberbands in the partial ring for the charging pad.
I also used the spacer to accommodate smaller phones.
the socket is set to use the larger (14mm) arm one piece. You will have to sand it for a smooth fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!