Thingiverse
Another Bridge Test
von ceri
10
Downloads
2
Likes
0
Makes
After getting a new (E3D-V5) Hot end,
I had to try bridging, actually been promising myself for ages,
but one of the projects I am working on can now be printed,
knowing how far I can bridge.
There are no special settings in SLIC3R, but I think I might try to back-off on amount extruded, during 'bridging', also, my fan is a bit poor,
Will try again when fixed.
Ceri
I had to try bridging, actually been promising myself for ages,
but one of the projects I am working on can now be printed,
knowing how far I can bridge.
There are no special settings in SLIC3R, but I think I might try to back-off on amount extruded, during 'bridging', also, my fan is a bit poor,
Will try again when fixed.
Ceri
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
