Ant_Mast_QuickMount

Dremel 3d20 Printer

Designed with Meshmixer

I remixed a tent pole hook for a completely different use. original was for a 3/4 inch pole so i scaled it up by 266% Mine came out 50.2mm which is very close to the intended size. Hope this serves you well. I had 9 failed prints but I am pleased with this one.

Version 7
I have changed where I plan to mount this and did not like the thought of drilling the mount holes so have added three holes. I was originally planning to have the top hang several inches above the top of my trailer but this will allow it to now sit even or lower. I also did away with the bulky base I added. This is a work in progress.

I printed this one on FAST
infill 40%
Supports yes
I had to adjust my supports so that the swirl that was dangling on its side was completely supported otherwise it kept popping off and ruining the print. If your print bed could support this vertically I would bet the supports could be turned off but for my scale which was m