Anycubic Mega Zero - Filament guide

Hi,

So I put a new roll of filament on my Anycubic Mega Zero and it is so tightly wound that the filament would pull back and sometimes the roll would jump/ skip after the extruder pulled hard enough on the filament.
I decided to make a quick filament guide, so here it is.

Just remove the end cap of the frame at the top and slide this filament guide in. No bolt necessary.

**If you want a filament guide that has low friction then check out my other design that uses a (3d printed) bearing https://www.thingiverse.com/thing:4628529**

Hope you enjoy it!


P.S. The surface quality of the part in the photos isn't that good because I'm dumb. I orientated it incorrectly in Cura and had interface supports on. So don't do that :)

To make it print faster, I also made a version with holes.


**Update 13-10-2020: Just a quick tip. You can use my other designed part: https://www.thingiverse.com/thing:4613044 and place it on the end so that a closed loop is formed so that the fil