Anycubic Predator Enclosure

There are three sides that need to be enclosed on the Predator. The models I have included address the rear left and right sides (I will upload the front side at a later time). To complete this task, you will need to purchase 4 pieces of 20"x30" corrugated plastic board from Michaels:
https://www.michaels.com/plastic-corrugated-board-by-creatology/M10567770.html?dwvar_M10567770_size=20%22%20x%2030%22%20x%200.16%22&dwvar_M10567770_color=Black

I did mine in black, but they also sell white and transparent. You will use the full size of two of the boards, whereas the other board will be trimmed to about 4.5"x20"

You will need four 5mm bolts with T-nuts to install the bottom pieces, whereas the top pieces will use the existing bolts on the Predator.

I printed mine in full size on a Tronxy X5SA with a 400mm x 400mm bed, but you can split the models and glue them together if you have a smaller build plate.