Apollo GO Wheel Stand Chocks

As seen in the video below, these wheel stand chocks are suitable for the Apollo GO e-scooter Each wheel chock is composes of 5 parts:Left SideRight SideCenter SpacerFoot 1Foot 2The feet are all identical. The standard center spacer is 6mm thick. You can scale the center spacer if you want to fine tune the fit but the 6mm spacer fit my scooter on front and rear so it should also work for you. However, by scaling the center spacer it is a quick print and prevents you from having to reprint the large parts. In the LEFT side parts there is a pause in the print to allow you to place embedded hex nuts in place. They are designed for M6 hex nuts. See below for hardware. You will also need FOUR of each of the following hardware: M6 locking nutsM6 x 75 Socket Head Cap ScrewsAs an Amazon associate I may earn a small commission (at NO extra cost to you!) If you are looking for the Apollo GO scooter, please use my links to help support my work! APOLLO GO And use discount code “EMBRACEMAKING” to g