Slicer Discord
Apple TV Siri remote power button fix – Modelo 3D imprimible de Thingiverse Thingiverse

Apple TV Siri remote power button fix

por Adamow
4 Descargas
3 Likes
1 Makes
Ver Modelo
After a few years of usage, I observed that the power button of my Apple TV Siri Remote was wobbling, threatening to pop out of the casing.

And then, one day, it was gone. Missing, leaving a hole with an unreachable switch at the bottom. As I browsed the web, I found out I was not alone and Apple won’t refund or replace.

There is a thread in Apple's forum here where [people complain](https://discussions.apple.com/thread/255052386). Fun fact: each time I tried to share my solution, it was upvoted and then deleted by Apple a few minutes later, whereas solutions leading to buy accessories from Amazon are still online in the same thread. Cannot understand, won't try to.

An idea, Fusion 360, a prototype and then this: a simple cap with a flexible button and we can switch the TV on and off again!

The remote loses a bit of style but recovers its full functionalities.

I propose two versions: a simple band and a top covering one.

Be cautious when you clip the cap around the r
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

Adamow también publica en

68 modelos adicionales en 2 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección