Thingiverse
aPump Maxi bracket
door SuperOldboy
0
Downloads
0
Likes
0
Makes
This is a mounting bracket for the aPump maxi.
You can print it "standing up".
You have to take off the suction cup at the back for it to fit.
I put some tape over the hole where the suction cup was in.
also if you want to lower vibrations, put some tape on the back of the bracket so it doesn´t touch your aquarium cabinet.
You can print it "standing up".
You have to take off the suction cup at the back for it to fit.
I put some tape over the hole where the suction cup was in.
also if you want to lower vibrations, put some tape on the back of the bracket so it doesn´t touch your aquarium cabinet.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
