Thingiverse
AR Wall Rack
von edburks
7
Downloads
6
Likes
0
Makes
AR15 Wall Rack
Ability to add cable lock via slot in back of base.
Adjustable. Using set screw.
Parts needed:
(1) rod. 7mm (Arrow Shaft, Carriage Bolt, Round Stock) 100-200mm length...depending on AR.
(12) Drywall / Decking type screws. 2" Aggressive thread pitch. I used stainless steel screws I found. Kreg pocket screws you can find at Lowes may also be a good option. You'll figure it out.
Drill 1/8" (.125mm) in rod end so that the 2" screw will lock the peg in place.
Drill 1/8" (.125mm) in rod side (see pilot hole) and use 2" screw to lock rod at proper length.
Found that 50% infill and 10 walls worked good for PLA. Long print time. Other stronger materials can scale back infill and walls and time.
Print flat for strength.
Ability to add cable lock via slot in back of base.
Adjustable. Using set screw.
Parts needed:
(1) rod. 7mm (Arrow Shaft, Carriage Bolt, Round Stock) 100-200mm length...depending on AR.
(12) Drywall / Decking type screws. 2" Aggressive thread pitch. I used stainless steel screws I found. Kreg pocket screws you can find at Lowes may also be a good option. You'll figure it out.
Drill 1/8" (.125mm) in rod end so that the 2" screw will lock the peg in place.
Drill 1/8" (.125mm) in rod side (see pilot hole) and use 2" screw to lock rod at proper length.
Found that 50% infill and 10 walls worked good for PLA. Long print time. Other stronger materials can scale back infill and walls and time.
Print flat for strength.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!