MakerWorld
Electronics
Ver Modelo
Arduino/Elegoo Prototype Case
7
Descargas
2
Likes
0
Makes
An Arduino/Elegoo case that uses M2 screws to fasten its lid and Arduino board. There are eight different files, four with 0.3mm tolerance and four with 1mm tolerance. If used, make sure to have M2 screws and washers. It should only use four M2 screws and four M2 nuts.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
