MakerWorld
Electronics
Zum Modell
Arduino/Elegoo Prototype Case
7
Downloads
2
Likes
0
Makes
An Arduino/Elegoo case that uses M2 screws to fasten its lid and Arduino board. There are eight different files, four with 0.3mm tolerance and four with 1mm tolerance. If used, make sure to have M2 screws and washers. It should only use four M2 screws and four M2 nuts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
