Arduino Pro Mini Holder

#ARDUINO PRO MINI HOLDER

This is a very simple holder for Arduino Pro Mini, a very small, cheap Arduino (Aliexpress below 1EUR). The problem: because of this small size, there are no holes for fixing the board. But now, it´s solved! This holder holds the board without fixing it with screws. It´s printed in 15 minutes. The slots on side working as springs holding the board.

After printing remove support in both hooks with a small screwdriver. There are two versions: one for gluing, one with 2 screw-holes 3.2mm (M3).

First insert the RESET-Button side into the hooks, then press down other side of board. To release board, push one of flexible "ears" to side, tilt the board upwards, done.

This holder works perfect together with this programming/debugging clamp: [Link](https://www.thingiverse.com/thing:4973180)