Thingiverse
arm cuff
por AdamKnight
2
Descargas
0
Likes
0
Makes
arm cuff.
For the joint use a bit of 1.75mm fillment and melt the ends to make them flat. (do not weld them to the body). the ends will go black but if you sand them it will remove the black and be the right colour.
For the clamps on the sides you could use filiment or i think a paper clip will work.
For the joint use a bit of 1.75mm fillment and melt the ends to make them flat. (do not weld them to the body). the ends will go black but if you sand them it will remove the black and be the right colour.
For the clamps on the sides you could use filiment or i think a paper clip will work.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!